InFocus Projector SP LAMP 084 User Manual

Lamp Module Replacement Instructions: SP-LAMP-084  
NOTES:  
Always use the InFocus lamp module designed for your projector model. Using the wrong lamp module may cause premature lamp failure and possible  
damage to the projector.  
SP-LAMP-084 – Used in IN134UST, IN136UST  
projector. Use of non InFocus lamps may cause electrical shock and fire, and may void the projector warranty. InFocus is not liable for the performance,  
safety or certification of any other lamps.  
WARNINGS:  
The projector uses a high-pressure mercury glass lamp. The lamp may fail prematurely, or it may rupture with a popping sound if jolted, scratched, or  
handled while hot. The risk of lamp failure or rupture also increases as the lamp age increases; please replace the lamp when you see the “Replace  
Lamp” message.  
To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp.  
Unplug the power cord before replacing the lamp.  
Do not drop the lamp module. The glass may shatter and cause injury.  
Do not touch the glass surface of the lamp module. Fingerprints can obscure projection sharpness and may cause the glass to shatter.  
Be extremely careful when removing the lamp module. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The lamp  
module is designed to contain most of these fragments, but use caution when removing it.  
Before replacing a ruptured lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement.  
When replacing the lamp while the projector is ceiling-mounted, wear protective eyewear to prevent eye injury.  
Hg-Lamp contains mercury. Manage with accordance with local disposal laws. See www.lamprecycle.org  
1. Turn off the projector and unplug the power cord.  
2. Wait 30 minutes to allow the projector and lamp to cool  
thoroughly.  
3. Remove the screw on the lamp door.  
4. Remove the lamp door.  
5. Loosen the two captive screws that attach the lamp  
housing to the projector.  
NOTE: If the projector is installed on a ceiling mount, be  
careful not to drop the lamp module once the captive  
screws are loosened.  
6. Using the handle, carefully lift the lamp straight up, off of  
the alignment pins; being careful not to pinch the lamp  
connector. Dispose of the lamp in an environmentally  
proper manner.  
7. Install the new lamp module, aligning the pins properly.  
Be careful not to pinch the lamp connector.  
8. Tighten the screws. (NOTE: If the pins have not been  
aligned properly, the screws will not tighten securely.)  
9. Replace the lamp door by putting the lamp door down  
(the hinges should be aligned) and sliding it back into  
place.  
10. Replace the lamp door screw and tighten securely.  
11. Plug in the power cord and press the Power button to  
turn the projector back on.  
 

Jensen Clock Radio JCR 275 User Manual
JL Audio Car Speaker SB P CYNNE 10W6v2 BK User Manual
JVC Digital Camera GR DVF31 User Manual
JVC Stereo Amplifier KV RA2 User Manual
JVC Stereo System CA MXG51R User Manual
Kenmore Garbage Disposal 72785 User Manual
Kenwood Electric Heater trn0812tk User Manual
KitchenAid Refrigerator W10162462A User Manual
Klaxon Smoke Alarm 105 DC User Manual
Korg Musical Instrument Dynamic Phrase Synthesizer User Manual